National FWD Sportsman Engine

Bcarmon

All,  I'm looking to sell the engine out of my mod FWD.  This engine would be perfect for the rules in the new Nation FWD Sportsman class that Temple has started.  The engine is very reliable and makes very good power, it's very competitive on the east coast and should put you at the front of the new Dragon class.  Below are a list of parts, if you have any questions please give me a call at (315) 569-5341.  The asking price is $28,000, thanks Ben.

10.6" Dart race series block w/ .600" raised cam
and bushed lifters, Sonny Bryant billet 4.875" crankshaft

MGP aluminum rods w/ upgraded bolts, Diamond pistons w/ vertical gas ports

15:1 compression, tool steel pins, Total Seal 0.43,0.43,3/16 rings

Ati balancer, jesel belt drive and belt drive dist., 55 mm LSM cam, Isky red zone 0.937 lifters

manton pushrods, T&D rockers w/ one piece stands

Brodix PB2005 heads, fully ported by frankenstein, flow over 580 intake,
370 exhaust

billet runner sheetmetal tunnel ram intake, (2) Pro-Systems SV-1 carbs, Magnafuel regulator and lines

Enderle linkage, Stefs custom dry sump pan, Peterson 3 stage oil pump, braided drysump lines and filters

System 1 oil filter, Peterson oil tank w/ heater, Moroso 4 vane vacuum pump and acc., MSD crank trigger          

Moroso pro-40 wires, MSD pro-power coil and mount, CSR electric water pump, billet water neck and lines

Tilton super starter, Performance Welding custom headers 2 3/8 to 2 1/2 stepped
primaries,

w/ 4 1/2" merge collectors, Moroso sheetmetal valve covers, Calico coated bearings, copper head gaskets, signal seals

All ARP Fasteners, Moroso drive mandrel and belts

Extra spare parts, spare rockers, spare pushrods, spare lifters, set of rods, two extra pistons, valve springs